Crown Macro-Tech 5000vz

Crown Macro-Tech VZ Series

Macro-Tech 5000VZ Specifications

Signal-to-Noise Ratio: (A-weighted) Better than 105 dB below full rated power into 8 ohms with 26 dB gain. (Unweighted) Better than 100 dB below full rated power.
Input Impedance: Nominally 10 K ohms balanced and 5 K ohms unbalanced.
Controls: Enable, channel 1 and 2 level controls, stereo/mono switch (Stereo, Bridge-Mono, Parallel-Mono), ground lift switch, input sensitivity switch for each channel (0.775 V or 1.4 V for full rated output or a 26 dB voltage gain), Loudspeaker Offset Integration switch, compressor switch and VZ mode switches.
Connectors:

Inputs: Balanced 1/4-in. phone jacks and female XLR connectors on standard P.I.P. module.
Output: Multi-purpose high current output block for each channel.
P.I.P.: Standard P.I.P. connector accessible through back panel.
AC Line: Standard three-wire grounded connector.

Dimensions: 19 in. (48.3 cm) standard rack mount width, 5.25 in. (13.3 cm) height, 16 in. (40.6 cm) depth behind mounting surface.

Approximate Weight: 77 lbs. 9 oz. (35.2 kg).
Total Harmonic Distortion (THD): Less than 0.05% from 20 Hz to 1 kHz increasing linearly to 0.1% at 20kHz delivering rated power into 8 ohms.
Intermodulation Distortion (IMD): (60 Hz and 7 kHz 4:1) Less than 0.05% from less than 337 milliwatts to full rated power into 8 ohms at 26 dB gain.
Load Impedance: Rated for 2 to 8 ohms in Stereo, 4 to 16 ohms in Bridge-Mono and 1 to 4 ohms in Parallel-Mono mode. Safe with all types of loads.
Maximum Average Power At 1 kHz with No More than 0.1% THD:
Output Power per Channel in Stereo Mode with Both Channels Driven:

1,300 watts into 8 ohms, 2,000 watts into 4 ohms, 2,500 watts into 2 ohms.

Output Power in Bridge-Mono Mode:

5,000 watts into 4 ohms.